Be Nature's friendly, Nature will provide for you.
 
Home
About Us
Products
Contact Us
Feedback
FAQ
  Evapo-Rust  
     
 
Product Information
 
 
for more go to www.evapo-rust.com
 
 
Product Information

Non Toxic | Non-corrosive | Safe on skin | Non-flammable Contains no acids, bases, solvents or other toxic ingredients | Biodegradable water soluble | no fumes or bad odours.


EVAPO-RUSTTM is an amazing rust remover. A product of extensive research. EVAPO-RUST has been proven effective to remove even deep rust on all types of mild steel and iron. De-rust without dis-mantling. EVAPO-RUST will not harm copper, brass, aluminium, plastic, rubber or vinyl. Even more amazing, EVAPO-RUST will not remove non-oxide coatings, such as paint or chrome, that are still bonded to the surface. Do not use with Cadmium coated surfaces.

EVAPO-RUST can be used over and over until performance drops off. Pre-clean item, to remove oil and dirt. Rinse item and IMMERSE FULLY in EVAPO-RUST Once rust is removed, rinse item with water. To prevent rust, simply dip the item in EVAPO-RUST and allow to dry. One gallon de-rusts up to 300 of moderately rusted steel @ 20 square feet). EVAPO-RUST wil lremove blueing (and other oxide coatings) in approximately 30 minutes. It will not harm solder points or lead and preps the surface for blueing like no other product.

EVAPO-RUST is sewarble in neat form. If no hazardous contaminants are introduced, only the iron content of the solution should dictate the disposal method. In most cases, it can be safely put down the drain. Always dispose of product per local, state and federal regulations.

Evapo-rust has been proven effective to remove even deep rust on all types of mild steel and iron.It is safe on all surfaces and will not harm copper, brass, aluminium, galvanization, plastic, rubber or vinyl.

No special equipment is required. Simply immerse the rusted parts in the solution and let soak for a period. Light rust may be removed in as little as 5 minutes, heavily rusted parts may require overnight soaking.

This water pump was soaked in in EVAPO-RUST for two hours then rinsed with water. It was then dipped back in the solution to prevent re-rusting.

The photo on the right is the same part taken two weeks later.

 
 
     
Before
 
After
 
   
 
PERFORMANCE :
ENVIRONMENT :
* Rapidly removes rust
* Requires No special equipment
* Easy to use, Immerse part in solution
* Safe on soft metals, plastic, rubber,
* PVC and other surfaces
*Will not pit un-rusted steel

*Inhibits rust from reforming for up to 4 weeks
. No VOC's and HAP's
. No Solvents
. No Acids
. No Bases
. Non-Corrosive
. Non-Toxic
. Non-Flammable .Biodegradable
. Sewerable in neat form